What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 02:20

but this device (an Inductor) … impedes the rapid changes in the current.
This device then solves the entire problem.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
What makes outside showers appealing? Why are they not commonly seen?
A circuit breaker is similar, but is resettable.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
What is the best way to get revenge on people who hurt you?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What movies have not aged well?
This is where the MOV conducts again, and dissipated the energy.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Upvotes:
Subway owner buys popular chicken chain in $1 billion deal - PennLive.com
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Here is a simplified AC power diagram.
The other is “what does a “fuse” do?”
Why do flat-Earthers think the Earth is flat?
A fuse is a non-resetable over current circuit protector.
(Dc diagram shown, AC is similar).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Why are people becoming increasingly hostile to pro-lifers? I am pro-life.
In schematic diagrams this is the symbol for a fuse:
2024–10–14 [Omar Gharbi Omar Gharbi ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
An AC voltage/ current source, and an ac inductive load.
There are two important concepts here.
He then asserts :
Can you provide some examples of music with a free form structure?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This one hit behind the barn.
This is where this question deviates from being a 'generic' question, and becomes more specific.
At least they know the answer if they wanted it.
It seems Mohan does not understand the difference between a comment and an Answer.
One
But… the neutral is now “floating” because of the 1 ohm resistance.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
[image of Common-mode choke]
The bolt then partially travels down the line to your home.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What is lightning?
eight
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The third is lightning and “how it gets conducted into a home.”
These devices are installed between the “hot” and “neutral” and protective ground.
but I think this circuit , shows a few more pieces.
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes Rainy Season and Lightning.
so, what happens?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
There are three different concepts here that are getting confused.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is 'the assistant's answer'
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
He then describes the function of a fuse.
These are simplified answers to the original question, and does not change anything I wrote above.
At one ohm, the resistor has a maximum of 1 watt power.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–10[John johnson John Johnson ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
I post the exact comment here.
Because the load is inductive, the current lags the voltage.(by a bit).
Barnstars:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
First Sentence:
what exactly is a ‘surge’ protector?
One is “what exactly is in a ‘surge protector’ ? ”
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
the problem then depends on "how fast does the fuse operate?".
It also is a device that limits the change in current flow.
[old diagram got deleted by accident]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
But it can get overloaded, and no longer works.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
a photo is worth a thousand words.
For this case there are devices called Metal oxide varistors (MOV).
nine
2024–10–16 [ OO OLAOYE OYEBODE ]
Edit 2024–10.
What does a fuse do?
The MOV will conduct when the voltage exceeds 50% of line voltage.